How to Clean a Humidifier

By Martín Golia Last reviewed 6 min read

Empty, wipe dry and refill a portable humidifier every day, and clean it properly every third day: that is the EPA’s advice. Use low-mineral water such as distilled water, and keep indoor humidity at or below 50% so you are not feeding mold and dust mites.

A dirty humidifier does not just look bad. Bacteria and mold growing in the standing water can be sprayed into the air you breathe, and so can the minerals in tap water (that is the fine white dust on furniture near ultrasonic models).

Acoustic guitar room at Guitar Center humidified to 50% relative humidity in winter

Photo: “Acoustic guitar room at Guitar Center humidified to 50% relative humidity in winter” by B137, CC BY-SA 4.0, via Wikimedia Commons (licence).

The EPA schedule, as a checklist

When What to do
Every day Unplug, empty the tank, wipe all surfaces dry, refill with fresh water
Every third day Full clean: scrub off scale, deposits and film; rinse well
Whenever you use a cleaner Rinse the tank thoroughly so no chemical is misted into the air
Per the manual Replace filters, wicks or cartridges
End of season Clean, dry completely and store dry; throw out old filters

Source: EPA’s “Use and Care of Home Humidifiers”. For everything else in the house, see how often to wash everything. Your manufacturer’s manual comes first for your specific model, especially on what cleaners are allowed.

Step-by-step: the every-third-day clean

1. Unplug and empty

Unplug it, empty the tank and the base, and take off any removable parts.

2. Descale with vinegar

Most manuals allow white vinegar for removing mineral scale. Fill the tank partway with undiluted white vinegar, swish it around, and pour some into the base. Let it sit 20 to 30 minutes. (If your manual says otherwise, follow it.)

3. Scrub

Scrub the inside of the tank, the base and any small parts with a bottle brush or an old toothbrush. Pay attention to the corners and the little reservoir where water sits.

4. Rinse until it does not smell

Rinse every part with clean water several times. You should not smell any vinegar.

5. Disinfect (only if your manual says so)

Some manuals recommend a weak bleach or hydrogen peroxide rinse now and then. If you do it, do it on a different day from the vinegar or after a very thorough rinse, never together, and rinse again until there is no smell.

6. Dry and refill

Wipe everything dry and refill with distilled or demineralized water.

Why 50% matters

The EPA advises not to humidify above 50% relative humidity, because higher levels encourage mold, dust mites and other biological growth. Most people are comfortable around 30 to 50% in winter. A cheap hygrometer tells you where you are; some humidifiers have a built-in humidistat you can set.

Signs you are overdoing it: condensation on the inside of windows, damp spots on walls, or a musty smell.

Tap water or distilled?

Tap water works, but its minerals end up as scale in the tank and, in ultrasonic and impeller models, as white dust in the air. The EPA recommends water with low mineral content, such as distilled water. A gallon of distilled water usually costs less than $2 at a US supermarket.

Storing it for summer

Do a full clean, let every part dry completely for a day, throw out used filters or wicks, and store it in its box. Putting it away damp is how you open it next winter to a moldy surprise.

Dry air season is also mattress and bedding season: our guides on deep cleaning a mattress and when to replace pillows cover the dust-mite side of indoor air.

Sources

Always follow the label on your product. Labels are the legal use instructions in the US.

Pinterest image: Clean your humidifier every 3 days. Here's how

Save this for cleaning day. Pin it so you can find it later.

Save to Pinterest
Read next How to Clean a Kitchen Sponge (and When to Just Throw It Out)